How to Make a Remote Controlled 6V Doorbell

Question from customer:
I want to install a single channel remote to control my doorbell within the range of 150m. The old 6V doorbell was broken and I don’t want to repair the wires of doorbell. Ordinary wireless doorbell cannot be used because it doesn’t reach the distance I really want. I have an idea that a transmitter is connected to the doorbell button and relay in receiver is connected to doorbell. The only problem is the control range of remote need to reach about 150m. Would you like to recommend some favorable products?

Answer:
We recommend the 6V one channel 2000m receiver(S1U-DC06-ANT2) and long range transmitter (CB-1). Working voltage range of receiver is 6V. With normally open and close terminal, the voltage of the device being controlled is AC110~240V or DC0~28V. So it can be applied in 6V doorbell. Usually, you don’t have to supply additional power to doorbell because it can get 6V power from powered receiver when you connect them to the 6V power supply together. And the most significant is that it has extended external antenna which makes its control range up to 2000m (6000ft). You will be satisfied with this product.

According to your requirement, you can connect the button of the bell to the transmitter by two wires. Then connect the bell to the relay in the receiver.

Setting control mode Momentary: Connect Jumper-1.
When you press the button of the bell, RF signal will be sent out from transmitter to receiver. The receiver receives to turn on the relay, then the doorbell rings. Release the button, the doorbell stops ringing.

0~28V or 110V~240V Device is Remote Controlled by 8 Transmitters and One Receiver

Question from customer:
I want to install a set of wireless remote controls, include 8 transmitters in 8 different places (max. 500 m) and one receiver in a specific location. The transmitter transmits a wireless signal to control a closed contact.
Answer:
We recommend normally open/closed contact toggle remote control (S1T-DC12-ANT2+CB-1). According to your requirement, you can choose 8 transmitters (CB-1) to work with the receiver. There are normally open/closed contacts in it which are able to connect device activated by DC 0~28V or AC110~240V. With external extended antenna, its working distance has reached 2000M in the open field. You can use 8 transmitters to remote control receiver from different directions.

This kind of remote control is activated by DC12 power supply. Toggle Mode is the only working mode of it. Here is the wiring diagram. Initial state: A, B = Normally Closed; B, C = Normally Open. Wire your device to normally closed contact A&B terminals. If you do this, your device is turned on always, that is to say, your device will on work all the time.

When you press button on the transmitter (connect B and C, disconnect A and B), turn off device; When you press button again (disconnect B and C, connect A and B), turn on device.