2000m Momentary Controller for DC Motor

Question from customer:

I am looking for a radio transmitter receiver 1 channel, 24V, 500 to 1000m, and function: I support the button, close the relay; I loose the button, open the relay.

Answer:

We recommend the model of 1 channel Momentary 2000m remote control kit (S1M-DC24-ANT2& CB-1). Remote control kit with momentary mode is often used to control motor open/close for electrically operated door/lock/window/blind. Press and hold the button on transmitter, start the motor (close the relay); release the button, stop the motor(open the relay). With external extend antenna, its working distance can reach 2000m (6000ft) theoretically. We have three standard voltage: 9V, 12V, 24V. You can choose the 24V. Owing to one relay on the receiver, it won’t realize that DC motor runs in forward and reverse. It only switches off/ on DC motor.

And it is normally open and close relay contact, generally speaking, you should add additional power supply to controlled DC motor. Or you can use one power supply for receiver and DC motor at the same time. The wiring method is as follow.

Connect DC motor to B&C terminals. And wire motor to positive and negative terminals of battery. Wire positive and negative terminals of receiver to battery.

Operation is very easy.

Press and hold button, turn on motor.

Release button, turn off motor.

How to Remote Control 5 Lamps Individually

Question from Customer:
I am looking for 5 remote controls to control 5 individual lights in living room. Do you have any recommendations?

Answer:
We recommend the model of 1 channel 220V power output controller switch (S1X-AC220+2C-2), you can buy 5 sets.
It can control lights, motors, fans, electrically operated doors/locks/windows/blinds/cars or other appliances with AC 100~240V. You can turn on/off the receiver with transmitter (remote control) from any place within a reliable distance (about 100m); the wireless RF signal can pass through walls, floors and doors. With characteristics of direct power output, you don’t have to provide additional power to remote-controlled device since device can get power from receiver if receiver is charged.

Wiring diagram is here. Wire light to L&N terminals of “OUT “terminal. Each light will wired to each receiver.
There are three working modes in it. They are toggle, momentary and latched modes. Here, you can choose latched because there are two buttons of transmitter.
Setting control mode Latched: Do not connect Jumper-1 and Jumper-2.
Press button 1: Turn on light.
Press button 2: Turn off light.
You can switch off/ on any light at your option.